Here are some Safety operation rules for Blow molding machine:
<1> Before starting each shift, add lubricating oil to each moving part. (manipulator, manipulator guide rail, mold opening and closing guide rail)
<2> The swing arm 3-4 days/time. The large chain and small chain of the heating machine one time/month. Always check whether the main engine reducer and the heating machine reducer are short of oil. The main engine bearing can be every 3 months per time.
The above suggestions are only for semi-autimatic blow molding machine. The automatic blow molding machine has automatic lubrication oil device.
<3> Before production, check whether the moving parts are firm, whether the screws are loose or falling off, especially in places with strong impact force, and whether the belt transmission part is abnormal.
<4> When start machine, start motor first, after 30 seconds to start the heating part to prevent voltage fluctuations.Turn on cooling water before starting the heating.
<5> Check whether each emergency stop switch, safety door switch, and detection switch of the protection device are normal.
<6> Check the peform in, preform out and insert preform part.
<7> Check whether the lamp tube damages or breaks. Change it in time.
<8> Check whether each pneumatic component is leaking and whether the action is sensitive.
<9> Check whether the triplet abnormally leaks and blocks.
<10> Clean solenoid valve if abnormal.
<11> Clean and polish blowing mold regularly.
<12> To prevent the dirt blowing into valve, you must move slowly when opening the high and low pressure air source switch. At the same time, open the exhaust valve for 30 seconds to ensure air is clean.
<13> When starting the fully automatic blow molding machine, make sure that the mechanical parts are in good condition, no person and no foreign matter inside. Close the safety door.
<14> Check high-pressure air source, low-pressure air source, power supply and water source.
<15> After starting heater 2-3 minutes, oven temperature rises evenly. Press the preform in button.
7 thoughts on “Blow Molding Machine Safety Operation Rules”
Good post. I learn something totally new and challenging on blogs I stumbleupon every day. It will always be interesting to read through articles from other writers and use a little something from other sites.
Nice post. I learn something totally new and challenging on websites I stumbleupon on a daily basis. It will always be interesting to read through content from other writers and use something from their websites.
you are really a good webmaster. The web site loading speed is amazing. It seems that you’re doing any unique trick. In addition, The contents are masterpiece. you have done a fantastic job on this topic!
Thank u for your compliment!
You made some nice points there. I did a search on the subject and found most persons will go along with with your blog.